MAX MXSA001 315MHz TPMS Tire Pressure Sensors for Toyota Instruction Manual

1. Taw qhia

This instruction manual provides essential information for the proper installation, operation, and maintenance of your MAX MXSA001 315MHz Tire Pressure Monitoring System (TPMS) sensors. These sensors are designed as direct replacements for various Toyota models, ensuring accurate tire pressure monitoring for enhanced safety and vehicle performance. Please read this manual thoroughly before installation and retain it for future reference.

2. Cov ntaub ntawv kev nyab xeeb

• Professional Installation pom zoo: Installation of TPMS sensors requires specialized tools and knowledge. It is highly recommended that these sensors be installed by a qualified technician.
• Correct Torque: Ensure valve stem nuts are tightened to the specified torque (4 Nm or 35 in-lbs) to prevent air leaks and sensor damage.
• Tyre Mounting: Exercise caution during tire mounting and demounting to avoid damaging the sensor.
• Compatibility: Verify that the sensors are compatible with your vehicle's make, model, and year before installation. Refer to the replacement OEM part numbers provided.
• Roj teeb lub neej: TPMS sensors contain non-replaceable batteries. The typical lifespan is 5-7 years, depending on usage.

3. Cov ntsiab lus ntawm pob

Muaj ib pob:

• 4 x MAX MXSA001 315MHz TPMS Sensors
• 4 x Silver Aluminum Valve Stems (pre-attached to sensors)

Daim duab 3.1: Tshajview of four MAX MXSA001 TPMS sensors.

4. Kev teeb tsa thiab kev teeb tsa

Proper installation is crucial for the correct functioning of the TPMS. It is strongly recommended that installation be performed by a certified automotive technician.

4.1 Pre-Installation Check

• Confirm that the MXSA001 sensors are the correct replacement for your vehicle's OEM part numbers (e.g., 4260733021, 4260706011, 4260733011, 426070C020, 426070C010, 42607AD020, 4260704010).
• Inspect each sensor for any visible damage before installation.

4.2 Sensor Mounting

1. Tshem lub log tsheb ntawm lub log.
2. Carefully remove the old TPMS sensor and valve stem.
3. Insert the new MAX MXSA001 sensor's valve stem through the valve hole from the inside of the rim.
4. Secure the valve stem nut from the outside, tightening it to 4 Nm (35 nyob rau hauv-lbs). Tsis txhob overtighten.
5. Ensure the sensor body is properly seated and does not interfere with the tire bead during mounting.
6. Mount the tire back onto the wheel, taking care not to damage the sensor.
7. Ntxiv cua rau lub log tsheb kom txog thaum lub log tsheb puv raws li qhov chaw tsim khoom pom zoo.

Figure 4.2.1: Close-up of a single MXSA001 sensor.

Daim duab 4.2.2: Sab view of the sensor and valve stem.

4.3 TPMS Relearn Procedure

After installing new TPMS sensors, your vehicle's TPMS control module must be reprogrammed or